This is an old revision of the document!
Solidoodle 3
Make/Model
Documentation
Settings
Print Envelope: 200mm x 200mm x 200mm (8“ x 8” x 8“)
ABS Extruder Temperature: 200˚
ABS Bed Temperature: 110˚
Software
Repetier Host
Repetier Host is used to control the printer.
Note: There is talk of switching to Printrun. — Pete Prodoehl 2014/04/10 21:55
Slic3r
Slic3r is used to generate G-code from your STL files. Slic3r can be run from within Repetier Host, or you can slice your files separately and load the G-code into Repetier Host.
Note that we've had a few issues with the settings taking effect when slicing within Repetier Host, so if things don't seem to be working, try slicing outside Repetier Host.
Current Status
OK
Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c.
Location
Approved Trainers
Checked Out Members
If you would like to get checked off to use this machine please contact one of the above listed trainers.
Wade Starck
-
Emily Mondloch
Mykal Antczak
Kaysy
Steve Shapiro
Sean Woodman
Matt Schedler
Luke Schedler
Bret Daniel
History
Notes
Paid for by
$70 - Joe B.
$100 - Lance L.
$20 - Pete P.
$100 - Vishal R.
$20 - Harvey M.
-
$200 - Jim K.
$200 - Ed K.
$20 - Chris H.
$50 - Adrian
$20 - Steve P.
$100 - Tony W.
TOTAL PLEDGED: $950