This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:stratasysfdm2000 [2013/10/23 15:12] haveblue [History] |
equipment:stratasysfdm2000 [2017/06/22 01:18] (current) mmelk [Current Status] |
||
---|---|---|---|
Line 6: | Line 6: | ||
* Stratasys FDM 2000 3D printer with ABS head | * Stratasys FDM 2000 3D printer with ABS head | ||
* 1.75mm filament | * 1.75mm filament | ||
- | * ABS or ABS+ plastic resin material (use _only_ Stratasys OEM filament) | + | * ABS or ABS+ plastic resin material (use _only_ Stratasys OEM filament |
* Currently located in the 3D Printing Area | * Currently located in the 3D Printing Area | ||
Line 15: | Line 15: | ||
* See Have Blue for Insight 8.1 (Stratasys control software, last version to support the FDM series) | * See Have Blue for Insight 8.1 (Stratasys control software, last version to support the FDM series) | ||
=====Current Status ===== | =====Current Status ===== | ||
- | * Fully functional except for the support | + | * Head has been rebuilt, |
- | * Still need a spare WinXP computer for running the printer. | + | * Spare WinXP computer for running the machine has been acquired. |
- | * Chip built a bottom shelf for the cart for storage of filament, parts, etc. | + | * June 2017: Nonfuctional. Needs calibration and a dedicated computer setup to run it. Computer is on hand, need monitor. |
=====On loan from ===== | =====On loan from ===== | ||
* Have Blue | * Have Blue | ||
Line 28: | Line 28: | ||
* 17OCT2013 - replaced inlet buffer, did full cleaning of support hotend, but support side seems clogged worse than before. | * 17OCT2013 - replaced inlet buffer, did full cleaning of support hotend, but support side seems clogged worse than before. | ||
* 22OCT2013 - Chip added a shelf to the cart for storage of filament. | * 22OCT2013 - Chip added a shelf to the cart for storage of filament. | ||
+ | * Late 2013/Early 2014 - disassembled head for removal of support extruder, support hotend cleaned, discovered manufacturing defect that should be easily fixed. | ||
+ | * 20APR2014 - fixed manufacturing defect in support hotend, polished internal passage, reassembled hotend with heater, thermocouple, | ||
+ | * 21APR2014 - discovered that the head rebuild didn't do squat and it was still jamming. | ||
+ | * 22APR2014 through 7MAY2014 - long, alcohol fueled depression (just kidding) | ||
+ | * 8MAY2014 - replaced support nozzle; jamming eliminated. | ||
+ | * 9MAY2014 - print completed successfully and there was much rejoicing. | ||
=====Notes ===== | =====Notes ===== |