This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:solidoodle3 [2014/04/17 01:08] kennethsbecker |
equipment:solidoodle3 [2019/04/01 15:06] (current) raster |
||
---|---|---|---|
Line 9: | Line 9: | ||
===== Documentation ===== | ===== Documentation ===== | ||
- | * [[http://www.solidoodle.com/ | + | * [[http://support.solidoodle.com/ |
- | * [[http://www.solidoodle.com/ | + | * [[http://support.solidoodle.com/ |
+ | * [[http:// | ||
* [[http:// | * [[http:// | ||
Line 17: | Line 18: | ||
* Print Envelope: 200mm x 200mm x 200mm (8" x 8" x 8") | * Print Envelope: 200mm x 200mm x 200mm (8" x 8" x 8") | ||
* ABS Extruder Temperature: | * ABS Extruder Temperature: | ||
- | * ABS Bed Temperature: | + | * ABS Bed Temperature: |
===== Software ===== | ===== Software ===== | ||
Line 38: | Line 39: | ||
===== Current Status ===== | ===== Current Status ===== | ||
- | * OK | + | * March 2019: Non-functional? |
+ | |||
+ | * December 2015: Having problems with over-temperature error messages when trying to print with ABS. | ||
+ | - Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | ||
+ | |||
+ | * June 2017: Out of commission for an extended period. Taken out of operation due to mechanical glitch which caused defects in every print. | ||
+ | * June 2017: E3D V6 hotend and Titan extruder transfered to TAZ for upgrades. | ||
===== Location ===== | ===== Location ===== | ||
Line 49: | Line 56: | ||
* [[members: | * [[members: | ||
* [[members: | * [[members: | ||
+ | * [[members: | ||
* Skittles (Lucy Sinogeikina) | * Skittles (Lucy Sinogeikina) | ||
Line 56: | Line 64: | ||
* Wade Starck | * Wade Starck | ||
* [[members: | * [[members: | ||
+ | * Emily Mondloch | ||
+ | * Mykal Antczak | ||
+ | * Kaysy | ||
+ | * Steve Shapiro | ||
+ | * Sean Woodman | ||
+ | * Matt Schedler | ||
+ | * Luke Schedler | ||
+ | * Bret Daniel | ||
+ | * [[members: | ||
===== History ===== | ===== History ===== | ||
* 2014-02-25 - Arrived at Makerspace\\ | * 2014-02-25 - Arrived at Makerspace\\ |