User Tools
equipment:solidoodle3
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
equipment:solidoodle3 [2015/12/12 00:35] the_digital_dentist |
equipment:solidoodle3 [2019/04/01 15:06] raster |
||
|---|---|---|---|
| Line 38: | Line 38: | ||
| ===== Current Status ===== | ===== Current Status ===== | ||
| + | |||
| + | * March 2019: Non-functional? | ||
| * December 2015: Having problems with over-temperature error messages when trying to print with ABS. | * December 2015: Having problems with over-temperature error messages when trying to print with ABS. | ||
| - Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | - Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | ||
| + | |||
| + | * June 2017: Out of commission for an extended period. Taken out of operation due to mechanical glitch which caused defects in every print. | ||
| + | * June 2017: E3D V6 hotend and Titan extruder transfered to TAZ for upgrades. | ||
| ===== Location ===== | ===== Location ===== | ||
equipment/solidoodle3.txt · Last modified: 2019/04/01 15:06 by raster
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
