This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
equipment:solidoodle3 [2014/10/29 19:23] bfelber [Checked Out Members] |
equipment:solidoodle3 [2015/12/12 00:35] the_digital_dentist |
||
---|---|---|---|
Line 9: | Line 9: | ||
===== Documentation ===== | ===== Documentation ===== | ||
- | * [[http://www.solidoodle.com/ | + | * [[http://support.solidoodle.com/ |
- | * [[http://www.solidoodle.com/ | + | * [[http://support.solidoodle.com/ |
+ | * [[http:// | ||
* [[http:// | * [[http:// | ||
Line 17: | Line 18: | ||
* Print Envelope: 200mm x 200mm x 200mm (8" x 8" x 8") | * Print Envelope: 200mm x 200mm x 200mm (8" x 8" x 8") | ||
* ABS Extruder Temperature: | * ABS Extruder Temperature: | ||
- | * ABS Bed Temperature: | + | * ABS Bed Temperature: |
===== Software ===== | ===== Software ===== | ||
Line 38: | Line 39: | ||
===== Current Status ===== | ===== Current Status ===== | ||
- | * OK | + | * December 2015: Having problems with over-temperature error messages when trying to print with ABS. |
- Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | - Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | ||
Line 50: | Line 51: | ||
* [[members: | * [[members: | ||
* [[members: | * [[members: | ||
+ | * [[members: | ||
* Skittles (Lucy Sinogeikina) | * Skittles (Lucy Sinogeikina) | ||