User Tools
equipment:tablesaw3
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
equipment:tablesaw3 [2018/01/17 18:02] spilon [Maintenance] |
equipment:tablesaw3 [2018/01/17 18:18] spilon [History] |
||
|---|---|---|---|
| Line 42: | Line 42: | ||
| ===== History ===== | ===== History ===== | ||
| - | 2017-12-01ish | + | Jan 15, 2018 - Replaced arbor, motor bearings and belts. Completely dismantled the internals of the saw down to the raw cabinet. Honed and polished the bearing surface for raising and lowering the blade, can now adjust height and tilt blade with two fingers, it used to take two hands. Rebuilt the locks for blade height and tilt angle. Replaced cord from the power box to the motor, wire insulation was cracked and missing.\\ |
| - | 2016-12-07 | + | Dec 1, 2017ish |
| - | 2015-07-01 | + | Dec 7, 2016 - Sprayed internal moving surfaces with dry lubricant. Helped loosen up a bit.\\ |
| + | Jan 7, 2015 - Arrived at Makerspace? | ||
| ===== Notes ===== | ===== Notes ===== | ||
equipment/tablesaw3.txt · Last modified: 2018/01/17 18:18 by spilon
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
