12“- 14” Rockwell Delta Crescent
Model Delta: 34-350
Serial Number: 6325-A
Fence: Vega Pro 50L

5 HP(actual, not peak) 3 phase motor
1“ arbor and 12” blades
We also have 5/8“ and 1 1/8” arbors
(Supposedly it will run anything up to a 14“ blade, but the 14” blade may not fully retract.)
Table size: 48“ wide X 38” deep
Fence: Current: Vega Pro 50L. Old/original: Jetlock type

OK

• Various

Arbor removal and bearing replacement: http://wiki.vintagemachinery.org/1214ArborBearings.ashx
Belts: 4x 4L280
Arbor bearings:
Blade side 6205
Pulley end 6204

Motor Bearings: 6206 & 6205(if you are finding this page for maintaining your own saw please realize this is not the original “bullet style” motor)

Wood Shop at Lenox

* Tom Gralewicz

Jan 15, 2018 - Replaced arbor, motor bearings and belts. Completely dismantled the internals of the saw down to the raw cabinet. Honed and polished the bearing surface for raising and lowering the blade, can now adjust height and tilt blade with two fingers, it used to take two hands. Rebuilt the locks for blade height and tilt angle. Replaced cord from the power box to the motor, wire insulation was cracked and missing.
Dec 1, 2017ish - Installed Vega Pro 50L fence. Tom Gra was returned the original fence in case we ever upgrade to a better saw.
Dec 7, 2016 - Sprayed internal moving surfaces with dry lubricant. Helped loosen up a bit.
Jan 7, 2015 - Arrived at Makerspace?

• Manual: delta_34-350.pdf
  
• Parts: table_saw_parts.pdf
  
• Fence: vega_fence_instructions.pdf

Don't have barcode reader? Click here.