User Tools
equipment:stratasysfdm2000
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
equipment:stratasysfdm2000 [2014/04/28 18:23] haveblue [Current Status] |
equipment:stratasysfdm2000 [2017/06/22 01:18] (current) mmelk [Current Status] |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| * Stratasys FDM 2000 3D printer with ABS head | * Stratasys FDM 2000 3D printer with ABS head | ||
| * 1.75mm filament | * 1.75mm filament | ||
| - | * ABS or ABS+ plastic resin material (use _only_ Stratasys OEM filament or equivalent - ask Have Blue if unsure about material suitability) | + | * ABS or ABS+ plastic resin material (use _only_ Stratasys OEM filament or equivalent |
| * Currently located in the 3D Printing Area | * Currently located in the 3D Printing Area | ||
| Line 15: | Line 15: | ||
| * See Have Blue for Insight 8.1 (Stratasys control software, last version to support the FDM series) | * See Have Blue for Insight 8.1 (Stratasys control software, last version to support the FDM series) | ||
| =====Current Status ===== | =====Current Status ===== | ||
| - | * Head is disassembled | + | * Head has been rebuilt, support nozzle has been replaced. |
| * Spare WinXP computer for running the machine has been acquired. | * Spare WinXP computer for running the machine has been acquired. | ||
| - | * Chip built a bottom shelf for the cart for storage of filament, parts, etc. | + | * June 2017: Nonfuctional. Needs calibration and a dedicated computer setup to run it. Computer is on hand, need monitor. |
| =====On loan from ===== | =====On loan from ===== | ||
| * Have Blue | * Have Blue | ||
| Line 30: | Line 30: | ||
| * Late 2013/Early 2014 - disassembled head for removal of support extruder, support hotend cleaned, discovered manufacturing defect that should be easily fixed. | * Late 2013/Early 2014 - disassembled head for removal of support extruder, support hotend cleaned, discovered manufacturing defect that should be easily fixed. | ||
| * 20APR2014 - fixed manufacturing defect in support hotend, polished internal passage, reassembled hotend with heater, thermocouple, | * 20APR2014 - fixed manufacturing defect in support hotend, polished internal passage, reassembled hotend with heater, thermocouple, | ||
| + | * 21APR2014 - discovered that the head rebuild didn't do squat and it was still jamming. | ||
| + | * 22APR2014 through 7MAY2014 - long, alcohol fueled depression (just kidding) | ||
| + | * 8MAY2014 - replaced support nozzle; jamming eliminated. | ||
| + | * 9MAY2014 - print completed successfully and there was much rejoicing. | ||
| =====Notes ===== | =====Notes ===== | ||
equipment/stratasysfdm2000.1398709402.txt.gz · Last modified: 2014/04/28 18:23 by haveblue
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
