Milwaukee Makerspace Wiki

User Tools

Site Tools

You are here: start » equipment » som_3d_printer
equipment:som_3d_printer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
equipment:som_3d_printer [2017/04/09 13:13]
the_digital_dentist 		equipment:som_3d_printer [2017/06/28 01:37] (current)
mmelk
Line 95: Line 95:
 For maximum print quality, print slowly.  In spite of posts you may see on the internet, there's absolutely no shame in printing at 30 or 40 mm/sec. For maximum print quality, print slowly.  In spite of posts you may see on the internet, there's absolutely no shame in printing at 30 or 40 mm/sec.
  
 +Trainers of SoM:
 +Mark R.
 +Mathew Melk
 +Erich Z
  
 +Certified Users of SoM: 
 +Mykal Antczak 
 +Tim Campbell 
 +Chad Lawson
  
  
equipment/som_3d_printer.txt · Last modified: 2017/06/28 01:37 by mmelk

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki