This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:dustcollector1ducts [2016/09/06 00:26] branth |
equipment:dustcollector1ducts [2016/09/06 00:52] (current) branth |
||
---|---|---|---|
Line 5: | Line 5: | ||
* Serves five 4" connections and a 6" duct to the table saw | * Serves five 4" connections and a 6" duct to the table saw | ||
{{: | {{: | ||
- | * A typical | + | * Each 4" connection has a DIY blast gate damper |
* Pull out on the black loop to open | * Pull out on the black loop to open | ||
* Push in to close | * Push in to close | ||
Line 15: | Line 15: | ||
* Open the panel on the front of the table saw and push sawdust into the inlet with a broom | * Open the panel on the front of the table saw and push sawdust into the inlet with a broom | ||
{{: | {{: | ||
- | Read more about the [[equipment: | + | * The on/off switch is a pushbutton down by the motor on the floor |
+ | * Read more about the [[equipment: |