User Tools
equipment:dustcollector1ducts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
equipment:dustcollector1ducts [2016/09/06 00:09] branth |
equipment:dustcollector1ducts [2016/09/06 00:52] (current) branth |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== " | ====== " | ||
| - | {{: | + | {{: |
| - | {{: | + | * 6" duct system around the perimeter of the room |
| - | {{: | + | * Serves five 4" connections and a 6" duct to the table saw |
| + | {{: | ||
| + | * Each 4" connection has a DIY blast gate damper | ||
| + | * Pull out on the black loop to open | ||
| + | * Push in to close | ||
| + | * Connect flexible hose to which ever machine you're using | ||
| + | * Close other dampers before turning on dust collector | ||
| + | {{: | ||
| + | * There is no blast gate damper for the table saw | ||
| + | * Dust on the floor can be swept under the table saw and into the duct inlet | ||
| + | * Open the panel on the front of the table saw and push sawdust into the inlet with a broom | ||
| + | {{: | ||
| + | * The on/off switch is a pushbutton down by the motor on the floor | ||
| + | * Read more about the [[equipment: | ||
equipment/dustcollector1ducts.1473120543.txt.gz · Last modified: 2016/09/06 00:09 by branth
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
