This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
equipment:dustcollector1ducts [2016/09/05 23:37] branth created |
equipment:dustcollector1ducts [2016/09/06 00:52] (current) branth |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== " | ====== " | ||
+ | {{: | ||
+ | * 6" duct system around the perimeter of the room | ||
+ | * Serves five 4" connections and a 6" duct to the table saw | ||
+ | {{: | ||
+ | * Each 4" connection has a DIY blast gate damper | ||
+ | * Pull out on the black loop to open | ||
+ | * Push in to close | ||
+ | * Connect flexible hose to which ever machine you're using | ||
+ | * Close other dampers before turning on dust collector | ||
+ | {{: | ||
+ | * There is no blast gate damper for the table saw | ||
+ | * Dust on the floor can be swept under the table saw and into the duct inlet | ||
+ | * Open the panel on the front of the table saw and push sawdust into the inlet with a broom | ||
+ | {{: | ||
+ | * The on/off switch is a pushbutton down by the motor on the floor | ||
+ | * Read more about the [[equipment: |