This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
spacedocumentation:replicatorhowto [2012/08/08 20:12] raster |
spacedocumentation:replicatorhowto [2012/08/13 23:09] (current) raster |
||
---|---|---|---|
Line 29: | Line 29: | ||
You'll get this dialog box where you need to set all the parameters. | You'll get this dialog box where you need to set all the parameters. | ||
+ | |||
+ | (Select Skeinforge 50 when you have the option... it may be under a menu.) | ||
This shows the result of loading an STL file that is set to print with one just one extruder. (The right one.) | This shows the result of loading an STL file that is set to print with one just one extruder. (The right one.) | ||
Line 47: | Line 49: | ||
{{: | {{: | ||
+ | |||
+ | Once you generate your GCode file (which takes a long time because Skeinforge is sloooooow) it will save it in the same directory as your STL file. | ||
+ | |||
+ | Copy the .gcode file to an SD card and put it in the side of the Replicator. | ||
+ | |||
+ | ... more to come ... | ||
+ |