This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
spacedocumentation:lasercutterlenscleaninghowto [2013/08/12 16:23] branth [Lens and first mirror] |
spacedocumentation:lasercutterlenscleaninghowto [2013/11/20 23:32] raster |
||
---|---|---|---|
Line 128: | Line 128: | ||
+ | ===== More Notes on Cleaning ===== | ||
+ | The air assist nozzle has been oily and dirty. | ||
+ | |||
+ | The lens has had that coating...you know the one I mean...the foggy, scratchy coating that gets left when you forget to use the air assist while cutting! | ||
+ | |||
+ | This one may surprise you: streaks on the lens when it's been improperly cleaned. | ||
+ | * Put one drop of solution on one end of the Q-tip. | ||
+ | * Gently swirl in a circular motion on the lens. | ||
+ | * Switch to the dry end of the Q-tip and swirl some more until the solution has evaporated off the lens. | ||
+ | * The lens should look, more-or-less, | ||