User Tools
equipment:panelsaw
This is an old revision of the document!
Panel Saw
Make/Model
- Unknown
Specs
- Unknown
Current Status
- OK
Approved for use by
- Mike D'Amico (approved by Matt N on 07/10/12)
- Ed H. (approved by Matt N on 07/10/12)
- David S. (approved by Matt N on 07/10/12)
- Steve P. (approved by Matt N on 07/10/12)
- Bret D. (approved by Matt N on 07/10/12)
- Brant H. (approved by Matt N on 07/10/12)
- Vishal R. (approved by Matt N on 07/10/12)
- Matt F. (approved by Matt N on 07/10/12)
- Bob D. (approved by Matt N on 07/10/12)
- Jim R. (approved by Matt N on 07/18/12)
- Chris R. (approved by Matt N on 07/18/12)
- D. Buggs (approved by Matt N on 08/30/12)
Location
- Vehicle Bay by Workshop entrance
Paid for by
- David Buggs - $170
- Jack D - $50
- Ron Bean - $40
- Tom Gondek - $50
- Tom Graelwicz - $50
History
02/10/12 - Arrived at Makerspace
Notes
- Always get assistance cutting large material
- Use caution when placing extension cords across walk paths
QR Code
Don't have barcode reader? Click here.
equipment/panelsaw.1355243263.txt.gz · Last modified: 2012/12/11 16:27 by gralewicz
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
