Differences

This shows you the differences between two versions of the page.

--- equipment:makerbotreplicator [2015/02/11 00:49]
clawson [Checked Out Members]
+++ equipment:makerbotreplicator [2015/12/12 00:44]
the_digital_dentist
@@ Line 22: / Line 22: @@
   * [[http://www.sketchup.com|SketchUp]].  Used to create 3D images.
 =====Current Status =====
-  * Works fine!
+  * December 2015: Not working.  The controller board died for the second time and it has been sitting, waiting for someone to replace the controller board with Arduino/RAMPS.
-    - The Right extruder is out of commission until further notice. The Stepper driver appears to have gone bad but the left one is still working fine. The nozzle has been removed because it was dragging on prints and since it did not matter since it does not work. The stepper has been unplugged so that the board recognizes that it is out of commission and will not allow the nozzle to be heated. Make sure you set up your prints to use the left extruder.
 ===== 3D Printing Area Champion ======
-  * [[members:josephbozarth|Joseph Bozarth]]
+  * [[members:markrehorst|the_digital_dentist]]
   * [[members:jimkelly|Jim Kelly]]
 ===== Approved Trainers =====
 (These are the people who must check out a member so they can use the 3D printer.)
+  * [[members:markrehorst|the_digital_dentist]]
   * [[members:josephbozarth|Joseph Bozarth]]
   * [[members:jasongessner|jason g.]]

Milwaukee Makerspace Wiki