This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:lulzbottaz [2015/02/18 01:25] jimkelly [Checked Out Members] |
equipment:lulzbottaz [2017/06/22 01:10] mmelk [Current Status] |
||
---|---|---|---|
Line 6: | Line 6: | ||
{{ : | {{ : | ||
- | |||
===== Documentation ===== | ===== Documentation ===== | ||
Line 13: | Line 12: | ||
* [[http:// | * [[http:// | ||
* [[https:// | * [[https:// | ||
- | |||
===== Settings ===== | ===== Settings ===== | ||
Line 51: | Line 49: | ||
===== Current Status ===== | ===== Current Status ===== | ||
- | * 2014-08-17 - Works! | + | * June 2017: Not Operational. Needs the firmware upgraded to work with the new E3D V6 hotend and Titan extruder. Needs 12v to the hotend fan. |
+ | * June 2017: E3D V6 hotend installed with Titan extruder, donated from nonfunctional Solidoodle. | ||
===== Location ===== | ===== Location ===== | ||
- | * 3D Printing Lab | + | * 3D Printing Lab (In a large Coroplast box with a flip-up lid.) |
===== Approved Trainers ===== | ===== Approved Trainers ===== | ||
Line 97: | Line 96: | ||
* LulzBot suggests 230˚ for ABS, but in the initial testing 235˚ worked well for the Coex blue filament. YMMV. DO NOT set the extruder temperature to 240˚ or higher.You will destroy it! | * LulzBot suggests 230˚ for ABS, but in the initial testing 235˚ worked well for the Coex blue filament. YMMV. DO NOT set the extruder temperature to 240˚ or higher.You will destroy it! | ||
* The TAZ is open source! Find [[http:// | * The TAZ is open source! Find [[http:// | ||
+ | * We plan to switch the Taz to use 1.75mm filament once we go through all the 3mm we currently have at the space. | ||