This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
equipment:lulzbottaz [2015/02/18 01:20] jimkelly [Approved Trainers] |
equipment:lulzbottaz [2017/02/06 20:34] raster |
||
---|---|---|---|
Line 6: | Line 6: | ||
{{ : | {{ : | ||
- | |||
===== Documentation ===== | ===== Documentation ===== | ||
Line 13: | Line 12: | ||
* [[http:// | * [[http:// | ||
* [[https:// | * [[https:// | ||
- | |||
===== Settings ===== | ===== Settings ===== | ||
Line 55: | Line 53: | ||
===== Location ===== | ===== Location ===== | ||
- | * 3D Printing Lab | + | * 3D Printing Lab (In a large Coroplast box with a flip-up lid.) |
===== Approved Trainers ===== | ===== Approved Trainers ===== | ||
Line 79: | Line 77: | ||
* Bret Daniel | * Bret Daniel | ||
* Ed C. | * Ed C. | ||
+ | * Vishal Rana | ||
+ | * Chad Lawson | ||
===== History ===== | ===== History ===== | ||
Line 95: | Line 95: | ||
* LulzBot suggests 230˚ for ABS, but in the initial testing 235˚ worked well for the Coex blue filament. YMMV. DO NOT set the extruder temperature to 240˚ or higher.You will destroy it! | * LulzBot suggests 230˚ for ABS, but in the initial testing 235˚ worked well for the Coex blue filament. YMMV. DO NOT set the extruder temperature to 240˚ or higher.You will destroy it! | ||
* The TAZ is open source! Find [[http:// | * The TAZ is open source! Find [[http:// | ||
+ | * We plan to switch the Taz to use 1.75mm filament once we go through all the 3mm we currently have at the space. | ||