This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:4x8router [2018/05/31 02:28] spilon [History] |
equipment:4x8router [2023/02/22 17:59] (current) spilon [Settings] |
||
---|---|---|---|
Line 51: | Line 51: | ||
July 30, 2018: 120v control cabinet fan died, z axis driver heat watchdog tripped shutting down the z axis, z axis test working fine once it cooled down. (spilon) | July 30, 2018: 120v control cabinet fan died, z axis driver heat watchdog tripped shutting down the z axis, z axis test working fine once it cooled down. (spilon) | ||
+ | 2021 The original used ball screw broke, multiple valiant attempts were made to repair it but those proved unsuccessful. A new ball screw was purchased and the z axis was modified to accept the new ball screw. | ||
Line 57: | Line 58: | ||
| | ||
+ | Base cut setting for a 1/4" 2 flute square nose (straight or spiral flute)bit: | ||
+ | * 12,000 RPM | ||
+ | * 1/8" Depth of cut | ||
+ | * 120 Inch's per minute feed | ||
+ | * 50 Inch's per minute plunge rate | ||
| | ||