Laser Cutter Lab Legacy Page
This is not the correct page.
It remains for archival purposes only.
Laser Lab Co-Champions and Trainers
Trainers (for Norwich 100w)
How to get trained on the laser cutters!
Basic Lenox/ULS Laser Trainings:
If you are new to lasers, these trainings are offered sporadically as requested on MMS email list - while space is open to the general membership - Find Hapto's phone number on the members only list or the champion board (the internet has spiders) and send a text to get a training rolling. Lenox Laser trainings are limited to 3 people, to allow for hands on opportunities, and to gain confidence and competency on the equiptment. Refreshers are available as needed.
100w "Boss Laser" at Norwich
Boss Laser trainings will be offered on Mondays at 6pm by Carl Stevens in tandem with Model Mondays (and cancelled when that meeting is cancelled.) Confirm on the message board if needed.
Lenox Laser Lab
Norwich Laser Lab
Rules and Etiquette
If your project is going to take more than 1 1/2 hours, you need to reserve the laser cutter. Simply post on the members only board with the date and time as far in advance as you can. If you post less than 24 hours in advance, not everyone may have seen your request, so you might not get the exact time you want. Deal with it.
Check your optics before you start! If the optics are dirty, you will get a bad cut, but more importantly, dirty optics can cause damage to the machine, and decrease the lifespan of the laser tube.
If we find that someone hasn't used the air assist on the 60 watt, we will initiate a camera review and consider banning that person for an unspecified length of time…probably measured in months. There have been several situations where we have found the 60 watt unusable until the lens was extensively cleaned. These are expensive and there's no reason we should have to replace them quite so often.
If you are making a profit from something at the space (laser cutter or otherwise) the guidelines are that you should be contributing 5% of your profit towards the machines you are using, in order to pay for their upkeep, and wear and tear. This is only fair, you are making a profit, using someone else's machine. If you are not making a profit, but still using the machines to create a product, you should similarly be contributing towards the area funds. Please remember that even if you are running your business on these machines, you have no more right to use the machines than any other member, with the possible exception of the actual owner of the machine.
Norwich Laser Lab
Pic of Norwich Laser Lab (placeholder)
“Boss” 100w laser
50w ULS laser
FAQs / Howtos / Materials settings
Legacy wiki content
Authorized / Signed Off Users
Design & Software