This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
spacedocumentation:lasercutterinkscape [2016/03/07 21:27] nilesstonne |
spacedocumentation:lasercutterinkscape [2017/06/14 00:57] (current) tony3 |
||
---|---|---|---|
Line 2: | Line 2: | ||
It is no longer necessary to go through CorelDraw to get a drawing from Inkscape to the laser cutter. | It is no longer necessary to go through CorelDraw to get a drawing from Inkscape to the laser cutter. | ||
- | - In Inkscape, | + | - Open Inkscape |
+ | - Under Stroke Style, set Width to 0.001in (or 0.025mm) for all of your lines. | ||
- Make sure your line colors match one of the supported colors on the laser cutters (see wall chart on laser cutter room wall for the list). | - Make sure your line colors match one of the supported colors on the laser cutters (see wall chart on laser cutter room wall for the list). | ||
- | - Make sure your page size matches that of the appropriate laser cutter (24x12in for the 50W, 24x18in for the 60W). | ||
- Save your document as a PDF, selecting ' | - Save your document as a PDF, selecting ' | ||
- | - On the laser cutter PC, open the PDF using Adobe Reader | + | - On the laser cutter PC, open the PDF using Adobe Reader. |
- Print the document from Adobe Reader, setting the print properties per the [[spacedocumentation/ | - Print the document from Adobe Reader, setting the print properties per the [[spacedocumentation/ | ||