This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
spacedocumentation:lasercutterdraftsight [2013/02/18 16:25] nilesstonne |
spacedocumentation:lasercutterdraftsight [2015/08/21 02:11] (current) gralewicz |
||
---|---|---|---|
Line 10: | Line 10: | ||
* Etch: (GREEN) Things I'll want etched, but not cut through. | * Etch: (GREEN) Things I'll want etched, but not cut through. | ||
* OuterCut: (RED) The last cuts to do - this is typically the outside edge of the object, removing it from the overall work material. | * OuterCut: (RED) The last cuts to do - this is typically the outside edge of the object, removing it from the overall work material. | ||
+ | |||
+ | To laser cut directly from Draftsight, set the objects line width to 0.00" | ||
I was able to print fairly easily/well by creating the object in DraftSight, then exporting via " | I was able to print fairly easily/well by creating the object in DraftSight, then exporting via " |