User Tools
spacedocumentation:lasercutterdraftsight
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
spacedocumentation:lasercutterdraftsight [2013/02/18 16:25] nilesstonne |
spacedocumentation:lasercutterdraftsight [2015/08/21 02:11] gralewicz |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| * Etch: (GREEN) Things I'll want etched, but not cut through. | * Etch: (GREEN) Things I'll want etched, but not cut through. | ||
| * OuterCut: (RED) The last cuts to do - this is typically the outside edge of the object, removing it from the overall work material. | * OuterCut: (RED) The last cuts to do - this is typically the outside edge of the object, removing it from the overall work material. | ||
| + | |||
| + | To laser cut directly from Draftsight, set the objects line width to 0.00" | ||
| I was able to print fairly easily/well by creating the object in DraftSight, then exporting via " | I was able to print fairly easily/well by creating the object in DraftSight, then exporting via " | ||
spacedocumentation/lasercutterdraftsight.txt · Last modified: 2015/08/21 02:11 by gralewicz
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
