User Tools
projects:wienermobile
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
projects:wienermobile [2017/06/21 23:48] raster [Leaf Cells] |
projects:wienermobile [2017/10/04 02:11] (current) raster |
||
|---|---|---|---|
| Line 44: | Line 44: | ||
| {{: | {{: | ||
| + | |||
| + | Above is the original programming used in Detroit and Milwaukee. (2017-07-24) | ||
| + | |||
| + | Below is the programming we set for Pittsburgh, though it has not been tested yet! (2017-10-03) | ||
| + | |||
| + | {{: | ||
| + | |||
| + | |||
| The motor controller can be programmed using a special USB cable and Windows software from Golden Motors. The three areas we need to be most concerned with are highlighted in yellow. (We're mainly looking to deliver the most power we can without blowing the 30 amp fuse.) | The motor controller can be programmed using a special USB cable and Windows software from Golden Motors. The three areas we need to be most concerned with are highlighted in yellow. (We're mainly looking to deliver the most power we can without blowing the 30 amp fuse.) | ||
| Line 50: | Line 58: | ||
| ===== Leaf Cells ===== | ===== Leaf Cells ===== | ||
| + | |||
| + | {{: | ||
| The diagram below shows how Pack #1 of the two packs get connected with copper bars and then how the wires from the balancing cables of the charger gets connected. (STILL TO DO: photos, Pack #2, and more instructions.) | The diagram below shows how Pack #1 of the two packs get connected with copper bars and then how the wires from the balancing cables of the charger gets connected. (STILL TO DO: photos, Pack #2, and more instructions.) | ||
projects/wienermobile.1498088924.txt.gz · Last modified: 2017/06/21 23:48 by raster
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
