User Tools
projects:wienermobile
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
projects:wienermobile [2017/06/21 23:58] raster |
projects:wienermobile [2017/10/04 02:09] raster [Motor Controller] |
||
|---|---|---|---|
| Line 43: | Line 43: | ||
| We've broken out all the wires to a screw terminal block, numbered them, and added a label showing what is what. The connectors on the right side all have ring terminals crimped on them, and a bit of hot glue where the wire goes in as strain relief. The wires on the left (controller) side are all just put in by bare wire, but there is a lot of hot glue holding things in place. | We've broken out all the wires to a screw terminal block, numbered them, and added a label showing what is what. The connectors on the right side all have ring terminals crimped on them, and a bit of hot glue where the wire goes in as strain relief. The wires on the left (controller) side are all just put in by bare wire, but there is a lot of hot glue holding things in place. | ||
| - | {{: | + | {{: |
| The motor controller can be programmed using a special USB cable and Windows software from Golden Motors. The three areas we need to be most concerned with are highlighted in yellow. (We're mainly looking to deliver the most power we can without blowing the 30 amp fuse.) | The motor controller can be programmed using a special USB cable and Windows software from Golden Motors. The three areas we need to be most concerned with are highlighted in yellow. (We're mainly looking to deliver the most power we can without blowing the 30 amp fuse.) | ||
projects/wienermobile.txt · Last modified: 2017/10/04 02:11 by raster
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
