Differences

This shows you the differences between two versions of the page.

--- projects:ratrig3dprinter [2022/05/18 03:38]
wildapricot-klein_john [Electrical]
+++ projects:ratrig3dprinter [2022/05/18 03:48] (current)
wildapricot-klein_john [Electrical]
@@ Line 149: / Line 149: @@
 {{:projects:ratrig3dprinter:pxl_20220511_015949860-min.jpg?400|}}
-Shortened stepper wires and crimped JST connectors.
+Shortened stepper wires and crimped JST connectors and wired the 24-volt lines between the power supply, mainboard, and relay.
 The stepper wires included in the kit were too long and they were terminated with the wrong connectors. While they would have worked, the connectors would have been easily removed by mistake and the wires would have been a mess.
 {{:projects:ratrig3dprinter:pxl_20220515_210129938-min.jpg?400|}}
-Wired up the 24-volt power leads to the mainboard and the control leads from the mainboard to the relay.
+Printed a power socket housing and added in a fused socket with a switch.
+{{:projects:ratrig3dprinter:pxl_20220517_030355183-min.jpg?400|}}
+Added 120-volt wiring from the socket to the power supply and relay.
 {{:projects:ratrig3dprinter:pxl_20220517_030345741-min.jpg?400|}}
+Crimped custom connectors and wiring for the BLTouch and ADXL345 accelerometer.
+{{:projects:ratrig3dprinter:pxl_20220518_030428478-min.jpg?400|}}
+Added ground wires and a 24-volt socket and adapter to 5-volt USB to power the Raspberry Pi and tablet.
+{{:projects:ratrig3dprinter:pxl_20220518_030613067-min.jpg?400|}}
 ==== Firmware ====

Milwaukee Makerspace Wiki