Note: We had our first race at BarCampMilwaukee. Here's a recap: http://milwaukeemakerspace.org/2012/10/nerdy-derby-recap/

Also, see this: nerdyderby.com

• Probably Maker Faire Milwaukee

• Pleasant Prairie Mini Maker Faire - Nov 26, 2016

The 2013 track was built at the DCRL.

The following people have pledge money to make it happen:

• Buggs - $200 - PAID
• Pete - $30 - PAID
• Ed H. - $20 - PAID
• Vishal - $40 - PAID

TOTAL PAID: $290

Vishal has created a 3 lane timing system. Details: ????

The “standard” car parts. The only really important number is probably 1.75“ for the base of the vehicle, so the wheels will actually fit on the track. Besides that, an “anything goes” approach should be taken. Crank that Creativity Dial up to 11!

We do have two semi-rules: don't damage the track, and don't make anything so dangerous it could easily injure someone.

Links:

• http://en.wikibooks.org/wiki/How_To_Build_a_Pinewood_Derby_Car/Dimensions_and_specifications
• http://commons.wikimedia.org/wiki/Pinewood_derby

• 32mm x 9mm (You can go larger, but don't go much smaller. Though we started making 7mm wheels just to print faster and use less material.)
• Use a 1/16” drill bit to make the center hole
• Use 17ga. x 7/8“ wire nails