• The circuit breakers in Panel 2LP-2 are controlled by relays and switches contained in Panel 2LP-3.
• Individual 120-volt lighting loads are switched using an array of ten solid-state relays.
• Each relay controls a specific bank (or zone) of lights in either the West or East Room.
• Zones have not been significantly altered since Makerspace took occupancy of the Lenox building.
• Users identify the zones they wish to turn on or off using a zone map printout, then toggle the zone's corresponding switch.
• Red 'status' LEDs indicate which zones are on or off.
• The relays and 120-volt wiring are enclosed by a clear, Plexiglas panel. The metal breaker box cover is installed over that.

Back to Parent Page: Milwaukee Makerspace Lighting Controller

Back to Parent Page: Milwaukee Makerspace Lighting Controller