Differences

This shows you the differences between two versions of the page.

--- projects:cheerlight [2011/12/18 05:31]
raster
+++ projects:cheerlight [2012/03/06 13:35]
raster
@@ Line 11: / Line 11: @@
 I used an Arduino and a ShiftBrite, with a sketch that responds to input via a serial connection, so it does rely on a computer running a Perl script right now. (I could switch it to use the Ethernet Shield if I get ambitious.)
-The box is a plastic tray from a water painting set, with a black board on the front. I cut a piece of green construction paper for the tree, glued it onto the board to cover the hole I cut in it, and then glued a piece from a milk jug onto the inside to act as a diffuser.
+The box is a plastic tray from a water painting set, with a black board on the front. I cut a piece of green construction paper for the tree, glued it onto the board to cover the hole I cut in it, and then glued a piece from a milk jug onto the inside to act as a diffuser. (I'll admit the enclosure was a total last-minute hack, and I'm working on designing a new one.)
 There's a whole lot more info here:

Milwaukee Makerspace Wiki