Differences

This shows you the differences between two versions of the page.

--- members:rune_puzzle_prop [2013/07/17 11:47]
nilesstonne created
+++ members:rune_puzzle_prop [2013/07/17 11:51]
nilesstonne
@@ Line 4: / Line 4: @@
 ===== Project Description =====
 One of my friends requested that I help to make a prop for one of the events at GenCon.  They wanted a "Rune Wheel" with a selection of Runes on it that are split across three different rings.  The puzzle is to line up the runes, then interpret them.
 ===== Build Steps =====
@@ Line 15: / Line 17: @@
 ==== Second Try ====
-So, using additional foam - this time 1" foam for the inner two rings and 2" foam for the outer ring, I re-marked all of the wheels.  From there I transferred the drawings of the runes onto the foam.  This was a fairly slow process, as I did all of the transfers by hand and had to use some creative interpretation to make sure they all worked.
+So, using additional foam - this time 1" foam for the inner two rings and 2" foam for the outer ring, I re-marked all of the wheels.  From there I transferred the drawings of the runes onto the foam.  This was a fairly slow process, as I did all of the transfers by hand and had to use some creative interpretation to make sure they all worked.{{ :members:20130703_200452.jpg?direct&400|}}
 Once the runes were sketched I used a Dremel with an engraving bit and engraved out all of the shapes.  It was a somewhat time-consuming process, but it turned out quite well.

Milwaukee Makerspace Wiki