This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:tormach770 [2017/01/20 01:49] landerson |
equipment:tormach770 [2018/04/12 16:19] landerson [Notes] |
||
---|---|---|---|
Line 7: | Line 7: | ||
===== Specs ===== | ===== Specs ===== | ||
- | *Spindle Motor: 1HP | + | *Spindle Motor: 1HP |
+ | *Spindle Speed: 175-3250 | ||
+ | *Feed Rate : 135 IPM (X,Y), 110 IPM (Z) | ||
+ | *Travel | ||
+ | * Table Size : 26" x 8" | ||
+ | * Error : < | ||
*{{um10350_pcnc770_manual_0616a_web.pdf|Manual}} | *{{um10350_pcnc770_manual_0616a_web.pdf|Manual}} | ||
Line 26: | Line 31: | ||
* Do NOT machine wood! | * Do NOT machine wood! | ||
* Plastic is allowed. | * Plastic is allowed. | ||
- | * Its a good idea to check if the vise is square before use. | + | * It' |
* Shown below is the part you'll be trained to make via conversational programming | * Shown below is the part you'll be trained to make via conversational programming | ||
{{: | {{: |