This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Last revision Both sides next revision | ||
equipment:solidoodle3 [2015/12/12 00:35] the_digital_dentist |
equipment:solidoodle3 [2017/06/22 01:06] mmelk [Current Status] |
||
---|---|---|---|
Line 41: | Line 41: | ||
* December 2015: Having problems with over-temperature error messages when trying to print with ABS. | * December 2015: Having problems with over-temperature error messages when trying to print with ABS. | ||
- Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | - Note: The extruder reads 25c-30c cooler than it actually is. If you want to print at 230c (for abs) you should set the hot end to 200c. | ||
+ | |||
+ | * June 2017: Out of commission for an extended period. Taken out of operation due to mechanical glitch which caused defects in every print. | ||
+ | * June 2017: E3D V6 hotend and Titan extruder transfered to TAZ for upgrades. | ||
===== Location ===== | ===== Location ===== |