This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
equipment:shapeoko2 [2018/04/08 03:09] wildapricot-king-dee_billy [History] |
equipment:shapeoko2 [2018/04/08 03:22] wildapricot-king-dee_billy |
||
---|---|---|---|
Line 4: | Line 4: | ||
\\ | \\ | ||
==== Pictures ==== | ==== Pictures ==== | ||
- | {{: | + | {{: |
Line 11: | Line 11: | ||
Donated by | Donated by | ||
* Our friends at [[https:// | * Our friends at [[https:// | ||
+ | {{ : | ||
==== Trainers ==== | ==== Trainers ==== | ||
Line 26: | Line 26: | ||
| | ||
- | Information\\ | + | |
- | Information\\ | + | |
| | ||
Line 35: | Line 34: | ||
CNC Room | CNC Room | ||
- | | + | |
- | * This is a list | + | * Add Locktite to everything! Vibrations make things loosen. :/ |
- | * The second item | + | * Build a hold-down table and make clamps. |
- | * You may have different levels | + | * Get more bits? |
- | * Another item | + | * Find a better fitting Dremel (or fab some new tool clamps) |
- | + | | |
- | - The same list but ordered | + | |
- | | + | |
- | - Just use indention for deeper levels | + | |
- | - That's it | + | |
| | ||
- | Information\\ | + | |
- | Information\\ | + | |
| | ||
Line 59: | Line 53: | ||
====Operating Instructions ==== | ====Operating Instructions ==== | ||
- | Information\\ | + | |
- | Information\\ | + | |
| | ||
| | ||
| | ||
- | Information\\ | + | * If connecting with GrblController the baud rate should be 9600. (See the above section for settings.) |
- | Information\\ | + | |
==== Documentation ==== | ==== Documentation ==== | ||
Line 77: | Line 70: | ||
* [[http:// | * [[http:// | ||
+ | ~~BARCODE~class=barcode_right~url=http:// |