This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
equipment:shapeoko2 [2018/04/08 03:05] wildapricot-king-dee_billy [Operating Instructions] |
equipment:shapeoko2 [2018/04/08 03:52] wildapricot-king-dee_billy |
||
---|---|---|---|
Line 4: | Line 4: | ||
\\ | \\ | ||
==== Pictures ==== | ==== Pictures ==== | ||
- | {{: | + | {{: |
Line 11: | Line 11: | ||
Donated by | Donated by | ||
* Our friends at [[https:// | * Our friends at [[https:// | ||
+ | {{ : | ||
==== Trainers ==== | ==== Trainers ==== | ||
{{: | {{: | ||
{{: | {{: | ||
- | {{: | + | {{: |
- | + | ====Current Status ==== | |
+ | {{: | ||
==== Make/Model ==== | ==== Make/Model ==== | ||
Shapeoko 2 | Shapeoko 2 | ||
Line 26: | Line 27: | ||
| | ||
- | Information\\ | ||
- | Information\\ | ||
- | | ||
- | {{: | ||
- | | ||
- | Information\\ | ||
- | Information\\ | ||
- | | ||
- | * This is a list | ||
- | * The second item | ||
- | * You may have different levels | ||
- | * Another item | ||
- | - The same list but ordered | + | |
- | | + | CNC Room |
- | - Just use indention for deeper levels | + | |
- | | + | |
+ | | ||
+ | * Build a hold-down table and make clamps. | ||
+ | | ||
+ | * Find a better fitting Dremel (or fab some new tool clamps) | ||
+ | * Print/make upgrade parts. | ||
| | ||
- | Information\\ | + | |
- | Information\\ | + | |
| | ||
- | 10/ | + | * 2014-08-01 - Arrived at Makerspace |
- | 09/2015 - Information\\ | + | * 2014-09-01 - Assembly began |
+ | * 2015-01-15 - Operational | ||
+ | * 2017-05-17 - Non-operational | ||
- | - ====Operating Instructions ==== | ||
- | Information\\ | ||
- | Information\\ | ||
- | ====Settings==== | + | ====Operating Instructions ==== |
+ | |||
+ | |||
+ | ====Settings==== | ||
| | ||
| | ||
- | Information\\ | + | * If connecting with GrblController the baud rate should be 9600. (See the above section for settings.) |
- | Information\\ | + | |
==== Documentation ==== | ==== Documentation ==== | ||
Line 75: | Line 70: | ||
* [[http:// | * [[http:// | ||
+ | ~~BARCODE~class=barcode_right~url=http:// |