This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:matsuura [2015/03/25 00:03] gralewicz [Notes] |
equipment:matsuura [2017/11/23 03:04] (current) raster |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Red Dragon - Matsuura RA1F - Vertical Machining Center ====== | ====== Red Dragon - Matsuura RA1F - Vertical Machining Center ====== | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
- | {{: | + | {{: |
===== Make/Model ===== | ===== Make/Model ===== | ||
Line 8: | Line 8: | ||
| | ||
208v/ | 208v/ | ||
- | |||
- | | ||
- | Bad spindle motor | ||
| | ||
- | Metal Shop at Lenox\\ | + | Removed from the space\\ |
| | ||
Line 22: | Line 19: | ||
| | ||
+ | |||
+ | Follow the directions in "Red Dragon Startup Procedure" | ||
+ | |||
+ | Copy your G-code to the computer connected to the Red Dragon. | ||
+ | |||
+ | Run XXXX to transfer your file to the Red Dragon | ||
+ | |||
+ | On the Red Dragon set the mode to " | ||
+ | Push the " | ||
+ | Select " | ||
+ | Enter the file number you want to use, it should start with the letter ' | ||
+ | Press " | ||
+ | |||
+ | On the PC | ||
+ | |||
+ | |||
+ | Note: If the transfer is having problems make sure parameters PM0009 thru PM0020 match the parameter file below on this page. | ||
+ | |||
Line 109: | Line 124: | ||
Parameter file - downloaded parameter file - working configuration | Parameter file - downloaded parameter file - working configuration | ||
{{: | {{: | ||
+ | ~~BARCODE~class=barcode_right~~ | ||