This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
equipment:makerbotreplicator [2015/02/11 00:49] clawson [Checked Out Members] |
equipment:makerbotreplicator [2017/06/22 01:16] (current) mmelk [Current Status] |
||
---|---|---|---|
Line 21: | Line 21: | ||
* [[http:// | * [[http:// | ||
* [[http:// | * [[http:// | ||
- | =====Current Status ===== | ||
- | * Works fine! | ||
- | - The Right extruder is out of commission until further notice. The Stepper driver appears to have gone bad but the left one is still working fine. The nozzle has been removed because it was dragging on prints and since it did not matter since it does not work. The stepper has been unplugged so that the board recognizes that it is out of commission and will not allow the nozzle to be heated. Make sure you set up your prints to use the left extruder. | ||
+ | =====Current Status ===== | ||
+ | * December 2015: Not working. | ||
+ | * June 2017: Nonfunctional. There are no plans to revive this printer. It has become a donor machine and educational tool for instruction on the fatal flaws of cheaply built 3D printers. Do not remove from 3D printing lab. | ||
===== 3D Printing Area Champion ====== | ===== 3D Printing Area Champion ====== | ||
- | * [[members:josephbozarth|Joseph Bozarth]] | + | * [[members:markrehorst|the_digital_dentist]] |
* [[members: | * [[members: | ||
===== Approved Trainers ===== | ===== Approved Trainers ===== | ||
(These are the people who must check out a member so they can use the 3D printer.) | (These are the people who must check out a member so they can use the 3D printer.) | ||
+ | * [[members: | ||
* [[members: | * [[members: | ||
* [[members: | * [[members: |