User Tools
equipment:lulzbottaz
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
equipment:lulzbottaz [2015/02/18 01:25] jimkelly [Checked Out Members] |
equipment:lulzbottaz [2017/02/06 20:34] raster |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| {{ : | {{ : | ||
| - | |||
| ===== Documentation ===== | ===== Documentation ===== | ||
| Line 13: | Line 12: | ||
| * [[http:// | * [[http:// | ||
| * [[https:// | * [[https:// | ||
| - | |||
| ===== Settings ===== | ===== Settings ===== | ||
| Line 55: | Line 53: | ||
| ===== Location ===== | ===== Location ===== | ||
| - | * 3D Printing Lab | + | * 3D Printing Lab (In a large Coroplast box with a flip-up lid.) |
| ===== Approved Trainers ===== | ===== Approved Trainers ===== | ||
| Line 97: | Line 95: | ||
| * LulzBot suggests 230˚ for ABS, but in the initial testing 235˚ worked well for the Coex blue filament. YMMV. DO NOT set the extruder temperature to 240˚ or higher.You will destroy it! | * LulzBot suggests 230˚ for ABS, but in the initial testing 235˚ worked well for the Coex blue filament. YMMV. DO NOT set the extruder temperature to 240˚ or higher.You will destroy it! | ||
| * The TAZ is open source! Find [[http:// | * The TAZ is open source! Find [[http:// | ||
| + | * We plan to switch the Taz to use 1.75mm filament once we go through all the 3mm we currently have at the space. | ||
equipment/lulzbottaz.txt · Last modified: 2017/06/22 01:10 by mmelk
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
