User Tools
equipment:lasercutterx30
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
equipment:lasercutterx30 [2017/12/03 02:31] marcinp [Location] |
equipment:lasercutterx30 [2018/08/09 02:57] marcinp [History] |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| * [[https:// | * [[https:// | ||
| * This accessory is almost 6" tall and reduces the workable Z-axis height, so if you need more room, temporarily remove it. | * This accessory is almost 6" tall and reduces the workable Z-axis height, so if you need more room, temporarily remove it. | ||
| + | * IP Address: 10.1.1.23 | ||
| ===== Current Status ===== | ===== Current Status ===== | ||
| Line 43: | Line 44: | ||
| * 11/21/2017 - Inspection by Marcin | * 11/21/2017 - Inspection by Marcin | ||
| * 12/02/2017 - Made available for general use | * 12/02/2017 - Made available for general use | ||
| + | * 08/08/2018 - Replaced x-axis stepper motor Lin Engineering 4109V-51 3.6V 1.2A | ||
| ===== Notes ===== | ===== Notes ===== | ||
| * Do not bump the machine while it is running, the magnetic safeties are sensitive and will kill the laser if it thinks the lid is open. | * Do not bump the machine while it is running, the magnetic safeties are sensitive and will kill the laser if it thinks the lid is open. | ||
equipment/lasercutterx30.txt · Last modified: 2023/09/13 03:30 by branth
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
