User Tools
equipment:lasercutterx30
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
equipment:lasercutterx30 [2017/12/03 02:26] marcinp [Current Status] |
equipment:lasercutterx30 [2017/12/05 23:23] marcinp [Specs] |
||
|---|---|---|---|
| Line 13: | Line 13: | ||
| * [[https:// | * [[https:// | ||
| * This accessory is almost 6" tall and reduces the workable Z-axis height, so if you need more room, temporarily remove it. | * This accessory is almost 6" tall and reduces the workable Z-axis height, so if you need more room, temporarily remove it. | ||
| + | * IP Address: 10.1.1.23 | ||
| ===== Current Status ===== | ===== Current Status ===== | ||
| Line 28: | Line 29: | ||
| ===== Location ===== | ===== Location ===== | ||
| * Current: Laser Cutter Room (back wall, middle) | * Current: Laser Cutter Room (back wall, middle) | ||
| + | * Computer: Immediately to the left on the left side of the table | ||
| ===== Manual ===== | ===== Manual ===== | ||
equipment/lasercutterx30.txt · Last modified: 2023/09/13 03:30 by branth
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
