User Tools
equipment:dustcollector1ducts
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
equipment:dustcollector1ducts [2016/09/06 00:26] branth |
equipment:dustcollector1ducts [2016/09/06 00:52] branth |
||
|---|---|---|---|
| Line 5: | Line 5: | ||
| * Serves five 4" connections and a 6" duct to the table saw | * Serves five 4" connections and a 6" duct to the table saw | ||
| {{: | {{: | ||
| - | * A typical | + | * Each 4" connection has a DIY blast gate damper |
| * Pull out on the black loop to open | * Pull out on the black loop to open | ||
| * Push in to close | * Push in to close | ||
| Line 15: | Line 15: | ||
| * Open the panel on the front of the table saw and push sawdust into the inlet with a broom | * Open the panel on the front of the table saw and push sawdust into the inlet with a broom | ||
| {{: | {{: | ||
| - | Read more about the [[equipment: | + | * The on/off switch is a pushbutton down by the motor on the floor |
| + | * Read more about the [[equipment: | ||
equipment/dustcollector1ducts.txt · Last modified: 2016/09/06 00:52 by branth
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
