This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
areas:vacuumformer [2017/10/19 14:37] wildapricot-campbell_timothy [FAQs / Howtos / Materials settings] |
areas:vacuumformer [2017/12/07 17:14] wildapricot-campbell_timothy [Training, Rules, and Etiquette] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Vacuum | + | ====== Vacuum |
~~NOTOC~~ | ~~NOTOC~~ | ||
{{: | {{: | ||
- | ===== Trainers | + | ===== Area Champion |
[[members: | [[members: | ||
- | ===== Rules and Etiquette ===== | + | ===== Training, |
- | The heating elements on the vacuum former | + | |
+ | In order to use the vacuum former, members must be signed off by an area champion after completing training. Training classes take place at least once per month (usually twice, depending on member interest), immediately following the 7pm public meeting. If you would like to schedule | ||
+ | |||
+ | |||
+ | Training Classes: | ||
+ | *Costs $5.00 | ||
+ | * Typically take <30 minutes | ||
Don't break anything, please. | Don't break anything, please. | ||
Line 16: | Line 22: | ||
===== Machines ===== | ===== Machines ===== | ||
* [[Equipment/ | * [[Equipment/ | ||
+ | ===== Setup and Operation ===== | ||
+ | |||
+ | The heating elements on the vacuum former reach >150° Centigrade (about 300° Fahrenheit). Although it is safe to briefly touch the plastic while it is at temperature, | ||
===== FAQs ===== | ===== FAQs ===== | ||
**" | **" |