Table of Contents
"Katy Perry" 30-watt Laser Cutter
Make/Model
Specs
Current Status
Location
Manual
Material Settings
History
Notes
"Katy Perry" 30-watt Laser Cutter
Make/Model
Universal Laser Systems / ULS-X30
S/N 4084
Built in February 1999
Specs
30 Watt CO2 Laser (dated 2012)
19mm dia / 50.6 mm Focal Length ZnSe Lens
Work Area: 32“ x 18”
No air assist
Has motorized z-axis control with auto-focus
Flow-Through Cutting Table
This accessory is almost 6“ tall and reduces the workable Z-axis height, so if you need more room, temporarily remove it.
IP Address: 10.1.1.23
Current Status
ONLINE
The
kerf
using this laser is amazing!
Multiple black spots on Lens
No known adverse effects (yet)
We have replacements but will wait
Some of the alignment screws for Mirror #2 are stripped
Closing the top lid does not always align with magnetic safety switches
Panel flashes
RED
when not properly aligned
You must
nudge
the lid to the right to re-align
Panel flashes
GREEN
when properly aligned
Location
Current: Laser Cutter Room (back wall, middle)
Computer: Immediately to the left on the left side of the table
Manual
Spiral-bound book titled “X25/50/100 Users Manual”
Even more documentation, manuals, etc in green manila folder
Material Settings
Laser Cutter Settings & Material Library
History
06/07/2008 - Replaced power supply
09/15/2017 - Arrived at Makerspace
10/04/2017 - Inspection by Tom
11/21/2017 - Inspection by Marcin
12/02/2017 - Made available for general use
08/08/2018 - Replaced x-axis stepper motor Lin Engineering 4109V-51 3.6V 1.2A
Notes
Do not bump the machine while it is running, the magnetic safeties are sensitive and will kill the laser if it thinks the lid is open.
Please read about the
ventilation system
.
30-watt laser lens conditions
The Laser Cutter is expensive and dangerous.
DO NOT
leave it unattended. Things can start on fire.
Some jobs take a long time to run. If you need to run to the bathroom or something, find someone to watch it for you.
A full tutorial is in progress:
Laser Cutter HOW TO
A rough tutorial on
Using DraftSight with the Laser Cutter
.